At the Asterisk cli you can try to type in:
misdn <tab> <tab>
Now you should see the misdn cli commands:
- clean
-> pid (cleans a broken call, use with care, leads often
to a segmentation fault)
- send
-> display (sends a Text Message to a Asterisk channel,
this channel must be an misdn channel)
- set
-> debug (sets debug level)
- show
-> config (shows the configuration options)
-> channels (shows the current active misdn channels)
-> channel (shows details about the given misdn channels)
-> stacks (shows the current ports, their protocols and states)
-> fullstacks (shows the current active and inactive misdn channels)
- restart
-> port (restarts given port (L2 Restart) )
- reload (reloads misdn.conf)
You can only use "misdn send display" when an Asterisk channel is created and isdn is in the correct state. "correct state" means that you have established a call to another phone (must not be isdn though).
Then you use it like this:
misdn send display mISDN/1/101 "Hello World!"
where 1 is the Port of the Card where the phone is plugged in, and 101 is the msn (callerid) of the Phone to send the text to.